Korg microSAMPLER Owner's Manual page 50

microSAMPLER
B4 FREQ (B4 Frequency) .................................................[20 Hz...20.00 kHz]
Specifies the center frequency of band 4.
B4 Q .............................................................................................. [0.5...10.0]
Specifies the width of band 4.
This parameter is visible and can be edited if B4 TYPE is set to "PEAKING."
B4 GAIN ......................................................................... [–18.0...+18.0dB]
Adjusts the gain of band 4.
4. DISTORT (Distortion)
This is a distortion effect that lets you use a 3-band EQ to obtain a wide
range of variation.
Wet: Mono In - Mono Out
Left
Pre EQ
Right
DRY/WET .............................................................. [DRY, 99:1...1:99, WET]
Adjusts the balance between the effect sound and the direct sound.
GAIN ..............................................................................................[0...127]
Specifies the degree of distortion.
PRE FREQ (Pre EQ Frequency) ........................................[20 Hz...20.00 kHz]
Specifies the center frequency of the PreEQ.
PRE Q (Pre EQ Q) .......................................................................... [0.5...10.0]
Specifies the band width of the PreEQ.
PRE GAIN (Pre EQ Gain)
Adjusts the gain of the PreEQ.
B1 FREQ (B1 Frequency) .................................................[20 Hz...20.00 kHz]
Specifies the center frequency of band 1.
50
Dry / Wet
3 Band PEQ
Distortion
Output Level
Dry / Wet
...............................................[–18.0...+18.0 dB]
B1 Q ............................................................................................... [0.5...10.0]
Specifies the width of band 1.
B1 GAIN ........................................................................ [–18.0...+18.0 dB]
Adjusts the gain of band 1.
B2 FREQ (B2 Frequency) ................................................ [20 Hz...20.00 kHz]
Specifies the center frequency of band 2.
B2 Q ............................................................................................... [0.5...10.0]
Specifies the width of band 2.
B2 GAIN ........................................................................ [–18.0...+18.0 dB]
Adjusts the gain of band 2.
B3 FREQ (B3 Frequency) ................................................ [20 Hz...20.00 kHz]
Specifies the center frequency of band 3.
B3 Q ............................................................................................... [0.5...10.0]
Specifies the width of band 3.
B3 GAIN ........................................................................ [–18.0...+18.0 dB]
Adjusts the gain of band 3.
OUT. LEVEL (Output Level) .............................................................. [0...127]
Adjusts the output level.