Korg microSAMPLER Owner's Manual page 61

19. PITCH.SFT (Pitch Shifter)
This effect changes the pitch of the input signal. You can choose one of three
types: fast response, minimal change in tonal character, and mid-way
between the first two types. This effect also provides a feedback delay that
lets you create special effects such as a pitch that keeps rising (or falling).
Wet: Mono In - Mono Out
Left
Feedback = PRE
Trim
Pitch Shifter
Trim
Right
DRY/WET .............................................................. [DRY, 99:1...1:99, WET]
Adjusts the balance between the effect sound and the direct sound.
PITCH (Pitch Shift) ................................................................... [–24...+24]
Adjusts the amount of pitch shift in semitone steps.
FINE ........................................................................................... [–100...+100]
Adjusts the amount of pitch shift in steps of one cent.
BPM SYNC (Delay Time Tempo Sync) ........................................... [OFF, ON]
☞p.52 "BPM SYNC (Delay Time Tempo Sync)"
TM RATIO (Time Ratio) .................... [BPM SYNC OFF: 0.5...400.0% (OVER)
/BPM SYNC ON: 12.5...400.0% (OVER)]
☞p.52 "TM RATIO (Time Ratio)"
DELAY (Delay Time) ..................................................[0...500 ms, 1/64...1/1]
The delay time is determined by this value and the TM RATIO value.
If BPM SYNC is "OFF," this can be adjusted in a range of "0–500 ms."
If BPM SYNC is "ON," the delay time is specified by the resolution you
select here relative to the tempo specified by BPM (☞p.22) or MIDI clock.
FB POS (FB Position) .................................................................. [PRE, POST]
Switches the feedback connection.
FEEDBACK .........................................................................................[0...127]
Adjusts the amount of feedback.
Dry / Wet
Feedback = POST
High Damp
Dry / Wet
MODE ....................................................................... [SLOW, MEDIUM, FAST]
Selects the pitch shifter's operating mode.
The "SLOW" setting produces minimal change in tonal character. The
"FAST" setting allows fast response to pitch change. The "MEDIUM" setting
is mid-way between these two settings. Try using "FAST" if you need only a
small amount of pitch change, or use "SLOW" if you need to shift the pitch
by a substantial amount.
HI DAMP ........................................................................................ [0...100%]
Specifies the amount of high-frequency damping.
TRIM .................................................................................................. [0...127]
Adjusts the input level to the effect.
20. TALK MOD (Talking Modulator)
This effect gives the input signal the characteristic of a person speaking.
Wet: Mono In - Mono Out
Left
Drive Talking Modulator
Right
Voice Top: A
Voice Center: I
LFO
Voice Bottom: U
Mod Depth
DRY/WET .............................................................. [DRY, 99:1...1:99, WET]
Adjusts the balance between the effect sound and the direct sound.
VO CTRL (Voice Control) .........................................[BOTTOM, –62...–01,
Controls the voice pattern.
VO TOP (Voice Top) ................................................................[A, I, U, E, O]
Specifies the vowel at the top of the control range.
VO.CENTER (Voice Center) ....................................................[A, I, U, E, O]
Specifies the vowel at the center of the control range.
Effect parameters
Dry / Wet
A - I - U - E - O
Dry / Wet
CENTER, +01...+62, TOP]
61