Korg microSAMPLER Owner's Manual page 40

Sampling keyboard
Table of Contents

Advertisement

microSAMPLER
USB
Only the USB connector will be used to transmit and receive MIDI mes-
sages.
PC USB-MIDI Port
microSAMPLER MIDI OUT
microSAMPLER KBD/KNOB
microSAMPLER MIDI IN
microSAMPLER SOUND
MIDI
Only the MIDI connectors will be used to transmit and receive MIDI
messages.
PC USB-MIDI Port
microSAMPLER MIDI OUT
microSAMPLER KBD/KNOB
microSAMPLER MIDI IN
microSAMPLER SOUND
MIDI CLK (MIDI Clock) ...............................[AUTO, INT, EXT USB, EXT MIDI]
This specifies how the microSAMPLER will synchronize with a connected
external MIDI device.
AUTO
If MIDI clock data is being received from an external MIDI device con-
nected to the MIDI IN connector (or USB connector), the microSAM-
PLER will automatically operate as with the "EXT MIDI" (or "EXT
USB") setting. If no such data is being received, it will operate using the
"INT" setting.
40
microSAMPLER
USB MIDI RX (EXT)
USB MIDI TX (INT)
USB MIDI TX (EXT)
USB MIDI RX (INT)
KBD/KNOB OUT
TG OUTPUT
etc...
etc...
microSAMPLER
USB MIDI RX (EXT)
USB MIDI TX (INT)
USB MIDI TX (EXT)
USB MIDI RX (INT)
KBD/KNOB OUT
TG OUTPUT
etc...
etc...
INT (Internal)
The microSAMPLER's pattern sequencer etc. will operate according to
its own internal clock setting (specified by the [TAP TEMPO] button or
the tempo parameter). Choose this setting if you're using the microSAM-
PLER as the master device to control an external MIDI device.
EXT USB (External USB)
MIDI OUT
The microSAMPLER's pattern sequencer etc. will operate according to
MIDI clock data received from the computer that's connected to the USB
port.
MIDI IN
EXT MIDI (External MIDI)
The microSAMPLER's pattern sequencer etc. will operate according to
MIDI clock data received from an external MIDI device that's connected
to the MIDI IN connector.
For details on synchronization-related settings for your external MIDI
device, refer to its owner's manual.
STRT.TRIM (Start Point Auto Trimming) ........................... [OFF...200 msec]
END TRIM (End Point Auto Trimming) .............................. [OFF...100 msec]
When you sample with the mic, the unwanted noises produced by pressing
the microSAMPLER's sampling button or keys to start or stop sampling can
be automatically trimmed off by the length of time you specify with these
MIDI OUT
two settings.
If you choose "OFF," sampling will start or stop the instant you perform the
MIDI IN
operation.
This setting is ignored if the rear panel AUDIO IN [
"LINE."
The STRT.TRIM setting is ignored if the sampling parameter TRIGGER is set to
"NOTE ON" or "THRE01...10."
/LINE] switch is set to

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents