D Dtmf Speed; Display Type - Icom IC-2300H Instruction Manual

Previous view
11
OTHER FUNCTIONS
D
Tone burst
Turn the Tone Burst function ON or OFF.
• OF : When you transmit a signal that superimposes
the CTCSS tone or subaudible tone, the squelch
tail noise may be audible on the RX side.
• ON : When you transmit a signal which superimposes
the CTCSS tone or subaudible tone, the squelch
tail noise is suppressed on the RX side.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
D
DTMF speed
Set the rate at which DTMF memories send individual
DTMF characters to accommodate your operating needs.
• 1 : 100 milliseconds interval; 5.0 cps speed (default)
• 2 : 200 milliseconds interval; 2.5 cps speed
• 3 : 300 milliseconds interval; 1.6 cps speed
• 5 : 500 milliseconds interval; 1.0 cps speed
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET MONI LOW
D

Display type

Set the display type for memory mode operation.
• FR : Displays the programmed frequency. (default)
• CH : Displays the memory channel number.*
• NM : Displays the channel name (if programmed)
*Only programmed memory channels can be selected.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/MHz
Frequency
D
Voltage display
Turn the Voltage Display function ON or OFF.
• OF : OFF.
• ON : The supplied voltage is displayed, when turning
ON the power. (default)
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET MONI LOW
Tone burst "OFF" (default)
DIGITAL PRIO AO BUSY
T-SCAN PRIO SCAN
TONE M/CALL V/MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/MHz
Memory channel number
DIGITAL PRIO AO BUSY
T-SCAN PRIO SCAN
TONE M/CALL V/MHz
49