Fujitsu PFU Rack2-Filer User Manual page 451

Program encountered an error while operating the binder.
This may be due to the following reasons.
- Cabinet cannot be found
- Network has been cut
- Not enough disk capacity
- A read-only LibRoot folder has been specified
Check that cabinet exists, the network environment, and status of
the LibRoot folder (existence, attributes).
Solution Check the following and try again.
• There is enough free space in the LibRoot folder or
temporary folder
• Write privilege is set for the LibRoot folder (a new file can
be created in the LibRoot folder)
• A connection is established if the LibRoot folder is on a
network
• There is a cabinet (press the [F5] key to refresh the
Rack2-Filer window)
Backup or restoration operation is being performed. WorkArea
cannot be started.
Solution Wait until the backup or restoration operation is complete, and
try again.
The necessary files do not exist.
Reinstall Rack2-Viewer.
Solution Rack2-Viewer may not be installed normally.
Uninstall, and then re-install Rack2-Viewer.
Rack2-Filer User's Guide
| 451