Fujitsu PFU Rack2-Filer User Manual page 411

[Problem]
Sheets are always scanned under the same conditions (scan pages, colors,
resolution, etc.) when using a scanner (TWAIN compatible).
On the Rack2-Viewer Window [Rack2-Viewer Settings] dialog box,
select [Display driver screen] in the [Scanner Insertion] tab.
After this is selected, when a scan is performed, the driver screen will
appear on which you can set conditions for scanning.
If [Display driver screen] is cleared, scanning is performed with the
specified settings, without displaying the scanner driver window.
[Problem]
The pages of a document are turned upside-down when scanned.
Refer to "7.6 Turning a Page Upside-down" (Page 172), and correct
the affected pages.
According to the document, the scan direction may not be corrected
properly. In this case, display the [Scanner Insertion] tab in the [Rack2-
Viewer Settings] dialog box of the Rack2-Viewer Window, and clear
[Automatically correct for upside-down scanner input].
[Problem]
When scanning a photo with the ScanSnap, the back side of the photo is also
scanned.
If there is writing on the back of the photo or if the back of the photo is
dirty, the back side of the photo may also be scanned, even if [Allow
automatic blank page removal] is selected.
To not scan the back side of photos, the following settings in ScanSnap
Manager are recommended:
• Right-click the "ScanSnap Manager" icon and select [Simplex
Scan].
• In the [Scanning] tab of the ScanSnap Manager settings
window, select [Simplex Scan (Single-sided)] for [Scanning
side].
Rack2-Filer User's Guide
| 411