Fujitsu PFU Rack2-Filer User Manual page 424

Chapter 13 Messages
The library name you entered already exists.
Enter other name, and try again.
Solution
Select a binder.
Solution
Program encountered an error while operating the binder.
This may be due to the following reasons.
- Cabinet cannot be found
- Network has been cut
- Not enough disk capacity
- A read-only LibRoot folder has been specified
Check that cabinet exists, the network environment, and status of
the LibRoot folder (existence, attributes).
Solution
The necessary files do not exist.
Reinstall Rack2-Viewer.
Solution
Rack2-Viewer has not been installed. Install it, and try again.
Solution
424 |
Rack2-Filer User's Guide
Enter another name as library name.
Select a binder and try again.
Check the following and try again.
• There is enough free space in the LibRoot folder or
temporary folder
• Write privilege is set for the LibRoot folder (a new file can
be created in the LibRoot folder)
• A connection is established when the LibRoot folder is on
a network
• There is a cabinet (press the [F5] key to refresh the
Rack2-Filer window)
Rack2-Viewer may not be installed normally.
Uninstall, and then re-install Rack2-Viewer.
Install the Rack2-Viewer window.