Scanning Documents Using The Scansnap - Fujitsu PFU Rack2-Filer User Manual

7.2
Scanning Documents Using the
ScanSnap
Operation in 2-Page Spread Mode
This section describes how to scan documents using the ScanSnap (S1100,
S1300, S1500, S300, S510, S500) and add the data to a binder.
1.
Insert the document into the ScanSnap.
2.
Open a page of the binder on which to scan the document.
3.
With the Rack2-Viewer window displayed as the front
window on screen, press the scan button on the ScanSnap
device.
The sheet is scanned and added into the binder.
When scanning documents using the ScanSnap, it is
necessary to use Rack2-Filer with the ScanSnap. For details
about how to enable the use of the ScanSnap with Rack2-Filer,
refer to "Chapter 5 Using the ScanSnap with Rack2-Filer"
(Page 65).
When using ScanSnap S1100, press the scan button again
after all documents have been scanned to end scanning
and add the sheets to the binder.
Rack2-Filer User's Guide
| 161