Removing The Operator Information Panel Assembly; Installing The Operator Information Panel Assembly - IBM System x3650 M3 4255 Service Manual

Removing the operator information panel assembly

To remove the operator information panel assembly, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Remove the cover (see "Removing the cover" on page 177).
3. Disconnect the cable from the back of the operator information panel assembly.
4. Reach inside the server and press the release tab; then, while you hold the
5. From the front of the server, carefully pull the operator information panel
6. If you are instructed to return the operator information panel assembly, follow all

Installing the operator information panel assembly

To install the replacement operator information panel assembly, complete the
following steps.
1. Position the operator information panel assembly so that the tabs face upward
2. Inside the server, connect the cable to the rear of the operator information panel
3. Install the cover (see "Installing the cover" on page 178).
4. Slide the server into the rack.
on page 169.
release tab down, push the assembly toward the front of the server.
assembly out of the server.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
and slide it into the server until it clicks into place.
assembly.
Chapter 5. Removing and replacing server components
233