6. Remove the screw from the safety cover.
7. Disconnect the hard disk drive backplane power cables from the connector in
8. Slide the cover forward to disengage it from the system board, and then lift it
9. If you are instructed to return the 240 VA safety cover, follow all packaging
Installing the 240 VA safety cover
To install the 240 VA safety cover, complete the following steps.
1. Line up and insert the tabs on the bottom of the safety cover into the slots on
2. Slide the safety cover toward the back of the server until it is secure.
front of the safety cover.
out of the server.
instructions, and use any packaging materials for shipping that are supplied to
you.
the system board.
Chapter 5. Removing and replacing server components
251