IBM System x3650 M3 4255 Service Manual page 250

To install the replacement battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the
2. Insert the new battery:
3. Reinstall any adapters that you removed.
4. Reconnect the internal cables that you disconnected (see "Internal cable routing
5. Install the cover (see "Installing the cover" on page 178).
6. Slide the server into the rack.
7. Reconnect the external cables; then, reconnect the power cords and turn on the
8. Start the Setup utility and reset the configuration.
232
IBM System x3650 M3 Types 4255, 7945, and 7949: Problem Determination and Service Guide
replacement battery.
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
c. If you removed a rubber cover from the battery holder, use your fingers to
install the battery cover on top of the battery connector.
and connectors" on page 172).
peripheral devices and the server.
Note: You must wait approximately 2.5 minutes after you connect the power
cord of the server to an electrical outlet before the power-control button
becomes active.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See Chapter 6, "Configuration information and instructions," on page 253 for
details.