3. Route the power cord through the power-supply handle and through any cable
4. Connect the power cord to a properly grounded electrical outlet.
5. Make sure that the error LED on the power supply is not lit, and that the dc
6. If you are replacing a power supply with one of a different wattage, apply the
Removing the battery
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
clamps on the rear of the server, to prevent the power cord from being
accidentally pulled out when you slide the server in and out of the rack.
power LED and ac power LED on the power supply are lit, indicating that the
power supply is operating correctly.
power information label provided with the new power supply over the existing
power information label on the server.
x.x/x.x
xx/xx HZ
Chapter 5. Removing and replacing server components
229