Lockout Function - Icom IC-41S Instruction Manual

D Time-Out timer (TOT)
The Time-Out Timer (TOT) function limits continuous trans-
mission to prevent accidental prolonged transmission, etc.
This timer cuts a transmission OFF after 1 min. of continuous
transmission.
TOT OFF (default)
D Lockout function
Select the transmission lockout (temporary transmission
inhibit) capability.
RP : Transmission is permitted only while
(Repeater Lockout)
receiving a matched CTCSS tone, or
receiving no signal.
BU : Transmission is inhibited while receiv-
(Busy Lockout)
ing a signal.
OF : No restriction for receiving a signal.
(OFF)
Lockout OFF (default)
TOT ON
Repeater lockout setting
D Scan resume timer
The scan resume condition can be set as a pause (P5) or
timer scan (15/10/5). When a signal disappears, scan
resumes after 5 sec. has passed regardless of the setting.
15/10/5 : Scan pauses for 15, 10 or 5 sec. when a signal is
detected, then resumes after that.
P5 : Scan pauses until the signal disappears and then
resumes after 5 sec.
Scan resume timer
P5 (default)
D Scan restart function
This function starts the scan after the transmission is per-
formed during scan and 10 sec. has passed.
Scan restart timer
OFF (default)
9
SET MODE
10 sec. setting
Scan restart timer ON
9
37