I Rx Frequency Setting (For Rx Channels Only) - Icom IC-41S Instruction Manual

I RX frequency setting
The receive frequency in the RX channels can be re-pro-
grammed within 450 to 520 MHz frequency range depending
on the setting.
D RX channel setting
The RX channels does not appear on the LCD (default;
"Inhibit" setting) and you cannot select it. So the RX channels
should be set to "Enable" before programming the RX fre-
quency.
q While pushing and holding
to indicate all pre-programmed RX channels (including the
inhibited channels.)
w Select the desired channel with [CH Up] or [CH Down],
* to set the displayed channel "Enable."
then push
"Inhibit" setting
e Turn the power OFF, then ON.
• The "Enable" channels appear on the LCD, and can be selected
with [CH Up]/[CH Down].
(for RX channels only)
* and * , turn power ON
"Enable" setting
D RX frequency programming
q Select the desired RX channel ('RX-XX'). (See at left)
w Push [Top]
to enter the function mode, then push
(Function)
and hold [Top]
(RX VFO)
mode.
* to toggle the bandwidth between wide or narrow.
• Push
RX channel
(in function mode)
e Push [CH Up] or [CH Down] several times to select the
desired frequency.
• The frequency changes according to the Wide/Narrow setting.
(p. 33)
Wide channel spacing
(25 kHz steps)
*Regardless of the assigned key function.
OTHER FUNCTIONS
for 2 sec. to enter the RX VFO
RX VFO mode
*Appears when Narrow
channel spacing is set.
Narrow channel spacing
(12.5 kHz steps)
8
8
31