Microphone Gain Level; Auto Power Save Function - Icom IC-41S Instruction Manual

9
SET MODE
D Beep level
Set the key-touch beep output level from 1 to 5.
Beep level 3 (default)
D Microphone gain level
Set the microphone gain level from 1 (Min) to 5 (Max).
Mic gain level 3 (default)
D Battery voltage indicator
This function controls display or non-display settings of the
connected battery pack's voltage when the power is ON.
• The voltage of the connected battery pack is displayed for 2 sec.
after power is turned ON.
Battery voltage
OFF (default)
36
D Signal Monitor function
This function controls the mute condition. The mute is re-
leased (audible) during SelCall code signal and roger beep
emission.
Beep level 1
D Auto power save function
The auto power save function reduces current drain by deac-
tivating the receiver circuit for preset interval.
This function will activate when no signal is received, and no
Mic gain level 1
operation is performed for 5 sec.
Battery voltage ON
Signal monitor ON (default)
Power save ON (default)
Signal monitor OFF
Power save OFF