I Memory Names; I Clearing The Memory Contents - Icom IC-A24 Instruction Manual

IC-A24-Nocl.qxd 04.9.1 5:50 PM

I Memory names

ï Programming memory names
The memory channel can display a 6-character names in-
stead of the programmed frequency.
q Rotate [DIAL] to select the desired frequency in the fre-
quency mode.
w Push
, then push [MR•
into the selected memory channel.
e Rotate [DIAL] to select the desired memory channel to be
programmed.
• Push [0• ] to select the BANK number if desired. Push
BANK
[CLR• ] to exit the BANK selection mode.
DEL
r Push [MR•
MW ] to enter the memory name programming
mode.
• "-- -- -- -- -- -- " appears on the display.
t Push the appropriate digit key several times to select the
desired character as listed at right.
• To erase a character, overwrite with a space (displayed as _).
• To move the cursor forwards or backwards, use [DIAL].
y Push [ENT•
] to program the name.
WX
• Flashing the memory name stops.
• When no name is programmed, the display shows the operating
frequency.
• To clear the programmed memory names, push [CLR•
fore pushing [ENT• ].
WX
Page 15
Key
ENT
] to program the contents
MW

I Clearing the memory contents

Unwanted memory channels can be cleared. Programming
over a memory channel also clears the previously pro-
grammed contents. Memory channel 1 cannot be cleared.
q Select the memory channel to be cleared.
w Push
DEL ] be-
MEMORY OPERATION
Character Key Character Key
1 1, Q, Z 2 2, A, B, C
4 4, G, H, I 5 5, J, K, L
7 7, P, R, S 8 8, T, U, V
Program 0 0, space, -
, then push and hold [CLR•
DEL
• "-- -- -- -- -- --" appears momentarily, then the next selec-
table channel appears.
4
1
2
Character
3
3 3, D, E, F
4
6 6, M, N, O
5
9 9, W, X, Y
6
7
8
9
10
11
12
13
] for 1 sec.
14
15
16
14