Ricoh MLP36n Manual page 99

Printer driver setup
Enabled paper feeding tray
Number of sheets that can be set
Both-sided printing
Additional cautions
Letterhead
Printer setup
Printer driver setup
Both-sided printing
Thick Paper
Paper thickness
Printer setup
Printer driver setup
Enabled paper feeding tray
Click [Plain] or [Plain/Recycled] in the "Paper type:" list.
Any input tray can be used.
Tray 1: 500
Tray 2, Tray 3 (Paper Feed Unit TK1030): 500
Bypass Tray: 100
• Make sure paper is not stacked higher than the upper limit
mark ( ) inside the tray. Make sure paper is not stacked
higher than the paper guides inside the bypass tray.
Possible
When printing on 91 - 130 g/m
slower to when printing on paper of 60 - 91 g/m
Make the following settings using the control panel:
• Press the [Menu] key, select [Paper Input], and then select
[Letterhead] for the selected tray's paper type.
Click [Letterhead] in the "Paper type:" list.
Possible
2
130 - 162 g/m (8 - 43 lb.)
Make the following settings using the control panel:
• Press the [Menu] key, select [Paper Input], and then select
[Thick Paper] for the selected tray's paper type.
Click [Thick] in the "Paper type:" list.
Any input tray can be used.
• Make sure paper is not stacked higher than the upper limit
mark ( ) inside the tray. Make sure paper is not stacked
higher than the paper guides inside the bypass tray.
Paper Recommendations
2
paper, print speed is slightly
2
.
5
79