Ricoh MLP36n Manual page 382

5. Making Printer Settings Using the Control Panel
• 60 seconds
• Default: 15 seconds
Network Setup
You can make network-related settings.
This menu appears only when the optional 802.11b interface unit is installed.
• For details about, see Hardware Guide.
IPv4 Settings
You can select whether to set the IPv4 address automatically or manually.
• DHCP
5
On/Off (Default: On)
• IPv4 Address
You can specify the IPv4 address.
When DHCP is set to on, the IPv4 address cannot be changed. To change it, set DHCP to
off. Contact your administrator for information about the network configuration.
• Subnet Mask
You can specify the subnet mask.
When DHCP is set to on, the subnet mask cannot be changed. To change it, set DHCP to
off. Contact your administrator for information about the network configuration.
• Gateway Address
You can specify the gateway address.
When DHCP is set to on, the gateway address cannot be changed. To change it, set DHCP
to off. Contact your administrator for information about the network configuration.
IPv6 Setting
• Stateless Sett.
You can enable or disable IPv6.
158
• Default: 0.0.0.0
• Default: 0.0.0.0
• Default: 0.0.0.0