Show; Slp; Smb - Ricoh MLP36n Manual

6. Monitoring and Configuring the Printer

show

Use the "show" command to display network interface board configuration settings.
View settings
msh> show
• If "-p" is added, you can view settings one by one.
• p.237 "Understanding the Displayed Information"

slp

Use "slp" command to view and configure SLP settings.
msh> slp ttl "ttl_val"
• You can search the NetWare server using SLP in the PureIP environment of NetWare 5/5.1 and
6
Netware 6/6.5. Using the "slp" command, you can configure the value of TTL which can be used by
SLP multicast packet.
• The default value of TTL is 1. A search is executed only within a local segment. If the router does not
support multicast, the settings are not available even if the TTL value is increased.
• The acceptable TTL value is between 1 and 255.

smb

Use the "smb" command to configure or delete the computer or workgroup name for SMB.
Computer Name settings
msh> smb comp "computer name"
• Set computer name using up to 15 characters. Names beginning with "RNP" or "rnp" cannot be
entered.
Working Group Name settings
msh> smb group "work group name"
• Set workgroup name using up to 15 characters
Comment settings
msh> smb comment "comment"
• Set comment using up to 31 characters
Notify print job completion
msh> smb notif {on | off}
216