5. If the gap is out of spec, carry out adjustment describe as follows.
6. Remove the 2 set screws holding the solenoid bracket in place, and remove the
solenoid together with the bracket.
Figure 6-62. Adjustment of the Paper Exit Opening Solenoid
7. Loosen the 2 screws holding the solenoid to the bracket, and adjust the position
of the solenoid.
8. Retighten the 2 solenoid screws, then replace the solenoid and bracket into their
original position and screw in the 2 bracket screws.
Figure 6-63. Adjustment of the Paper Exit Opening Solenoid
[Assembling Procedures]
1. Reinstall the rear cover, the top cover and the Cover Sheet Feeder (If installed)
reversing the procedure above.
M M
L
0 0
Disassembling, Assembling & Adjustment
6-41