Ricoh DDP92 Maintenance Manual page 112

5. Wind the opposite side of the wire (the long side) from the inside of the Up-down
Pulley toward the outside, and fix the wire end.
Figure 6-37. Assembly of the Up-down Wire
6. Press down on the Up-down Stay and refasten the four wire-bracket screws.
Figure 6-38. Assembly of the Up-down Wire
7. Loosen the two belt-tensioner set screws.
8. Using a Push-pull Gauge, pull the belt tensioner so that tension A is at the value
indicated below. Maintain this tension while re-tightening the screws.
Spec value for tension: A = 2.5±0.1kg.
Figure 6-39. Assembly of the Up-down Wire
M M L 0 0
Disassembling, Assembling & Adjustment
6-23