Ricoh DDP92 Maintenance Manual page 66

5.2.14. E1C8
PRIMARY FACTOR; Paper did not arrive at the Stacker Conveyance Passage PS in the Cover Sheet Feeder use.
PHENOMENON CAUSES & CHECK POINTS
1. This phenomenon 1.
occurs because
the paper has not
2.
arrive the Stacker
Conveyance
Passage PS.
3.
4.
5.
2. This phenomenon 1.
occurs though the
paper has arrive
at the Stacker
2.
Conveyance
Passage PS.
3.
Figure 5-12
Refer to
5.2.15. E1C9
PRIMARY FACTOR; Paper did not arrive at the Paper Exit 2 PS in the Cover Sheet Feeder use.
PHENOMENON CAUSES & CHECK POINTS
1. This phenomenon 1.
occurs because
the paper has not
2.
arrive the Paper
Exit 2 PS.
3.
2. This phenomenon 1.
occurs though the
paper has arrive
at the Paper Exit 2
2.
PS.
3.
Figure 5-12
Refer to
FNS INSERTER JAM 2
Foreign substance is on Remove: Foreign substance
the paper path.
Paper contacts the gate.
Sub-Tray Paper Exit Gate
Paper Path Switching Gate
The breaking of cables or Repair the cable or reset the
the disconnecting of connector
connectors. CN1 - SD1
Solenoid fault. Replace: Gate Solenoid (SD1)
PCB fault. Replace: FS-108H/HBM P/K
The breaking of cables or Repair the cable or reset the
the disconnecting of connector
connectors. CN1 - PS5
Sensor fault. Replace:
Stacker Conveyance Passage PS
(PS5)
PCB fault. Replace: FS-108H/HBM P/K
FNS INSERTER JAM 3
Foreign substance is on Remove: Foreign substance
the paper path.
Paper contacts the gate.
Sub-Tray Paper Exit Gate
Paper Path Switching Gate
PCB fault. Replace: FS-108H/HBM P/K
The breaking of cables or Repair the cable or reset the
the disconnecting of connector
connectors. CN1 - PS10
Sensor fault. Replace:
Paper Exit 2 PS (PS10)
PCB fault. Replace: FS-108H/HBM P/K
M M L 0 0
CORRECTIONS
Position adjustment:
CORRECTIONS
Position adjustment:
Maintenance
Ref + Page
6.3.3, 6-33
6.3.4, 6-35
3.5, 3-7
3.5, 3-7
3.4, 3-3
3.5, 3-7
Maintenance
Ref + Page
6.3.3, 6-33
6.3.4, 6-35
3.5, 3-7
3.4, 3-3
3.5, 3-7
5-21
Troubleshooting