Ricoh DDP92 Maintenance Manual page 111

[Assembling Procedures]
1. Move the Up-down Stay so that the inner wire which is not removed (the shorter
Figure 6-35. Assembly of the Up-down Wire
2. Wrap the shorter side of the wire (from the Wire Bracket) being exchanged
3. Adjust the wire-bracket position so that it is even@with the another wire bracket.
4. Fit the wire onto the Upper Pulley.
Figure 6-36. Assembly of the Up-down Wire
6-22
DDP92/184 Finisher Maintenance Manual
side from the Wire Bracket) is wound twice around the pulley.
around the Up-down Pulley twice.
Insert the pin, and then fasten the pulley into place with the E-ring.
M M L 0 0