Ricoh DDP92 Maintenance Manual page 146

[Adjustment Procedures]
1. Take a fold sample using A3 paper.
2. Check the discrepancy along the folded set's trailing edge, and use this informa-
tion to judge the direction and amount by which the stopper angle must be cor-
rected.
3. Loosen the 2 front set screws holding the stopper in place, and adjust the stopper
angle by rotating around the rear screw.
4. Retighten the 2 front screws.
5. Take another sample and check the discrepancy.
6. Repeat steps (3) and (4) until the discrepancy is within the specified limit.
7. Replace the adjustment cover.
Figure 6-84. Adjustment of the Folding Stopper
M M L 0 0
Disassembling, Assembling & Adjustment
6-57