[Adjustment Procedures]
1. Loosen the 3 set screws holding the flat-stapling stopper bracket in place, and
position the bracket so that distance A is within the specification range.
Spec range: A = 5.5 to 11.5mm
(initial value = 8.5mm)
2. Hold paper against the stoppers and confirm that all three stoppers are in align-
ment.
3. Execute stapling to confirm that the stopper line and stapler line are parallel.
Figure 6-75. Adjustment of the Stapling Position (Flat Stapling)
M M
L
0 0
Disassembling, Assembling & Adjustment
6-51