Ricoh DDP92 Maintenance Manual page 132

5. Hold down the paper exit-opening guide plate with your hand so that the paper
exit roller makes contact, and check that the remaining stroke for solenoid SD4
(distance B) is within spec.
Spec value: B = 2.5±0.5mm.
Figure 6-65. Adjustment of the Paper Exit Opening Solenoid
6. If either measurement is out of spec, carry out adjustment as described below.
7. Loosen the 2 set screws holding the solenoid bracket in place, and adjust the
position of the bracket so that distances A and B are within spec.
8. Retighten the 2 bracket set screws.
Figure 6-66. Adjustment of the Paper Exit Opening Solenoid
[Assembling Procedures]
1. Reinstall the rear cover, the top cover and the Cover Sheet Feeder (If installed)
reversing the procedure above.
M M L 0 0
Disassembling, Assembling & Adjustment
6-43