Qlogic SANbox 6142 User Manual page 277

A
Table B-10. Fibre Channel Driver—Error Log Messages (Continued)
ID
107254
107267
87
93
94
96
97
99
307
317
350
357
416
432
452
533
545
560
562
FI0054601-00 C
#%d: QLUpdateSinglePortCont 0x%x: out of slots in host
database
#%d: QLFcipIsrEventHandler: System error event (%x),
MB1=%x, MB2=%x, MB3=%x, MB4=%x, MB5=%x, MB6=%x,
MB7=%x
The FC processor received a SCSI command for an unknown target path or
has run out of resources to execute additional commands.
The FC processor was disabled by an IOCTL request to the driver.
The FC processor firmware failed initialization. The request to initialize was
received by the driver in an IOCTL request.
The FC processor failed the external loopback test.
The FC processor failed to re-initialize in response to an IOCTL disable
request.
Invalid Virtual Port loop ID.
The FC processor reported a link down condition.
The FC processor reported an unexpected asynchronous event. The mailbox
registers provide status, event code, and data related to the event.
FCIP Response queue entry TRB pointer is NULL.
The driver has determined that the FC link is unreliable and unusable due to
the number of errors encountered. The link has been taken down.
The FC processor was unable to obtain the number of loop IDs required. This
failure occurs only when the FC processor is running multi-ID firmware.
The driver was unable to re-establish connection to the target within the
timeout and retry counts, and is therefore marking it offline.
The FC processor is unable to log into the FC fabric name server.
The driver's host (initiator) database is full.
The driver's target database is full.
The driver's host (initiator) database is full. Maximum host database is 64.
FC processor "Get VP Database entry command" failed.
Log Messages
B – Log Messages
Error Log Messages
No.
758
771
B-21