Qlogic SANbox 6142 User Manual page 178

A – Command Reference
Commands
Admin Command
Opens and closes an administrator session. You can run any command that
changes the router configuration within an Admin session. Only one Admin
session can be open on the router at any time. An inactive Admin session will time
out after 15 minutes.
Authority
None
Syntax
admin
start (or begin)
end (or stop)
cancel
Keywords
start (or begin)
Opens the Admin session.
end (or stop)
Closes the Admin session. The Logout, Shutdown, and Reset commands will also
end an Admin session.
cancel
Terminates an Admin session opened by another user. Use this keyword with
care, because it terminates the Admin session without warning the other user and
without saving pending changes.
Notes
Closing a Telnet window during an Admin session does not release the session. In
this case, you must either wait for the Admin session to time out, or use the Admin
Cancel command.
Examples
Opening and closing an admin session example:
QRouter #> admin start
Password : ******
QRouter(admin) #>
...
QRouter(admin) #> admin end
QRouter #>
A-6
S
FI0054601-00 C