Qlogic SANbox 6142 User Manual page 183

A
Remote IPv6 Address
fe80::21b:21ff:fe06:d517
MTU Size (0=Normal, 1=Jumbo, 2=Other)
TCP Window Size (0=8KB, 1=16KB, 2=32KB)
Window Scaling (0=Enable, 1=Disable)
TCP Port No. (Min=1024, Max=65535)
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb)
FCIP Time Stamp (0=Enable, 1=Disable)
Resource Allocate TimeOut (Min=1sec, Max=5sec)[1
Bandwidth, Mbit/sec (Min=1, Max=1000)
VLAN (0=Enable, 1=Disable)
FCIP SW Compression (0=Enable, 1=Disable)
All attribute values for FCIP Route 1 will now be saved.
FCIP route modify command example:
QRouter (admin) #> fciproute mod
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE
ports.
Route
-----
1
Please select a FCIP route from the list above ('q' to quit): 1
Configuring FCIP Route: 1
---------------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled
IP Address (IPv4 or IPv6; 0=IPv6 Link Local)
Selected IPv6 Link Local Address: fe80::2c0:ddff:fe0c:8be2
Remote IPv6 Address [fe80::21b:21ff:fe06:d517]
fe80::21b:21ff:fe06:d514
MTU Size (0=Normal, 1=Jumbo, 2=Other)
FI0054601-00 C
FC Port ID GE Port ID
---------- ----------
FC1 GE1
A – Command Reference
Commands
[:: ]
[Normal ]
[32768 ]
[Disabled ]
[3225 ]
[Auto ]
[Enabled ]
]
[1000 ]
[Disabled ]
[Disabled ]
[::
[Normal
]
]
]
A-11