Qlogic SANbox 6142 User Manual page 270

B – Log Messages
Error Log Messages
98
100
107
117
136
146
147
151
274
278
297
305
307
308
310
312
323
B-14
Unable to create an object for the target device: exceeded the maximum
number of target devices.
Unable to create an object for the target node: exceeded the maximum
number of target devices.
Memory unavailable for LUN object.
Unable to create an object for initiator object: exceeded the maximum number
of initiators.
Process control block status indicates that a PCI error occurred during a target
operation.
Process control block status indicates that a DMA error occurred during an
initiator operation.
Process control block status indicates that a transport error (protocol)
occurred during an initiator operation.
Process control block status indicates that a data overrun error occurred
during an initiator operation.
iSCSI login failed between receipt of PDU and request for the data segment.
iSCSI login failed due to unsupported version number in received login PDU.
iSCSI Login PDU contains invalid initiator name. The format and character
set used to form the initiator name is invalid.
iSCSI target login was attempted to a portal (iSCSI1 or iSCSI2) on which the
target is not presented.
iSCSI Login PDU received for a target with a target name unknown to the
router.
iSCSI Login PDU received without a target name for a normal session.
iSCSI Login PDU received without an initiator name key/value.
iSCSI Login PDU received with an incorrect initiator task tag for a session
which is partially logged in. This would occur if a login PDU other than the
initial login PDU used an initiator task tag which was different than the initiator
task tag provided in the initial login PDU.
iSCSI Login PDU was received with a TSIH out of range. This would occur if
the iSCSI initiator attempting the login failed to used the TSIH value provided
in the Target Login Response PDU (router is target) in subsequent login PDUs.
S
FI0054601-00 C