Applying Changes To An Activated Policy - Extreme Networks Policy Manager User Manual

To assist in the selection of arguments for count, clicking the icon as shown above, displays a list of
"rule packet counters."
NOTE
The Enter arguments box provides different lists and reference options depending on which "match condition" or
"action" has been selected,
c Modify the parameters as needed and then click Save and Close. The parameter is changed.
Deleting parameters from a rule.
a To delete a parameter, select a parameter in either the Match Conditions, Actions, or Action
Modifiers text box. The Delete selected icon
b Click the Delete selected icon. A Confirm Delete box is displayed, an example of which is
shown below:
c Click Yes. The parameter is deleted from the rule.
Should the delete process be inconsistent with rule requirements, a Parameter Notice is displayed
that explains the requirements. For example:
d Continue the procedure as advised in the notice or cancel the process.

Applying Changes to an Activated Policy

When changes are needed in a policy that is currently activated on a switch (described
not necessary to deactivate the policy. The following steps incorporate changes to rules in an active
policy.
1 Use any of the procedures above to add, modify or delete parameters for a saved rule.
2 From the menu, choose Policy > Refresh. A Refresh Confirmation box is displayed.
3 Click Yes. An Operation Progress box is displayed followed by a Validation Notice stating that the
"Policy has been refreshed."
NOTE
The submenu command, Refresh, is enabled only when the policy being changed is currently activated on a switch.
Extreme Networks Policy Manager (EPM) 1.2 User Guide
is enabled.
Modifying Rules
on page 50), it is
47