Extreme Networks Policy Manager User Manual page 12

Installing The Extreme Networks Policy Manager
The switch must be running ExtremeXOS
●
The EPM requires a Secure Shell (SSH) module installed and running on the switch to manage policy
●
file transfer. The default state of SSH is "disabled", so ensure that this application has been enabled
using the
enable ssh2
To load and run the SSH module on a switch, use the following commands:
a Download image
where "
For example,
b
run update
c
enable ssh2
d
enable clear-flow (
For additional information, refer to the ExtremeXOS Command Reference Guide and the ExtremeXOS
Concepts Guide.
A Trivial File Transfer Protocol (TFTP) server must be installed and running prior to loading or
●
saving policy files using the EPM. The server is required to transfer policy files to and from switches.
Install an external TFTP server on port 69 and set the EPM's policy staging directory to the TFTP
server's root. Set the staging directory after the EPM is installed. (Refer to
use on a Switch" on page 18
procedures.)
Ensure that the EPM user has read/write permission to the installation directory and the TFTP
●
directory.
12
command.
<ip> <yy>-xxx-ssh.xmod primary
" is the switch type and "
yy
download image 10.1.1.1 bd10k-11.4.4.7-ssh.xmod primary
for CLEAR-Flow supported switches)
for information on setting the staging directory and other configuration
™
11.4 or later.
" is the release number
xxx
Extreme Networks Policy Manager (EPM) 1.2 User Guide
"Configuring the EPM for