Blank Front Panels - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

Figure 78: Indications that the Module is Unlocked
EX_161
3 Squeeze the release latch on each injector/ejector handle and rotate both handles outward to
disconnect the module from the chassis backplane (see
CAUTION
To prevent ESD damage, hold the module by the metal panel edges only. Never touch the components
on the PCB or the pins on any of the connectors.
4 Slide the module out of the chassis slot.
5 Immediately place the module into the anti-static bag to protect it from potential ESD damage. The
bag will also prevent dust from collecting on the module connectors.
6 If you are not going to install a replacement module, install a blank front panel. To install a
replacement module, follow the installation procedure starting
NOTE
Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available
when you need to touch ESD-sensitive components.

Blank Front Panels

BlackDiamond switches are shipped with blank front panels installed over one or more chassis slots.
You can remove or install a blank front panel at any time without disrupting network services.
Complete the action of installing a blank front panel in a reasonable time-frame to avoid disruption to
adequate airflow.
CAUTION
All unoccupied slots in a BlackDiamond 8800 series switch must have blank front panels correctly installed
to ensure conformance to FCC requirements as well as to maintain adequate airflow through the switch.
You need the following tools and equipment to install or remove a blank front panel:
ESD-preventive wrist strap
●
#2 Phillips screwdriver
●
BlackDiamond 8800 Series Switches Hardware Installation Guide
Yellow Band
on Captive
Screw Head
Handle
Release Latch
EX_173
Figure 78).
on page 113.
121