5 Tighten the captive screws in the middle and on each end of the power cord retainer (see
Figure
94).
Figure 94: Securing the BlackDiamond 8810 AC Power Cord Retainer
REMOVE TO INSTALL POWER CORDS
ASP012B
6 To power the system on, connect the other end of each installed AC power cord to the power source.
Disconnecting a BlackDiamond 8810 AC Power Cord
To disconnect a BlackDiamond 8810 AC power cord:
1 Disconnect the AC power cord from the power source.
2 Use a #2 Phillips screwdriver to loosen the captive screws in the middle and on each end of the
power cord retainer.
3 Remove the power cord retainer from the front of the switch.
4 Disconnect the power cord from the power input connector on the front of the switch.
BlackDiamond 8800 Series Switches Hardware Installation Guide
137