Verifying The Module Installation; Displaying Slot Status Information - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

Verifying the Module Installation

After you install a module, verify that it is working correctly by checking the LEDs on the front panel of
the module. Table 22 shows normal LED operation for correctly installed MSMs and I/O modules.
Use the command line interface (CLI)
information about the newly installed module.
Table 22: Module LED Activity for Normal Operation
LED State/Meaning
SYS Green blinking
MSTR Green: MSM is primary
Amber: MSM is backup
ENV Green
Link/Activity Green: Link is up.
Amber: Packet activity is occurring.
For more information about LED activity, see the module chapter for each switch series.

Displaying Slot Status Information

Assuming the module has no problems, the command
of the slot where you installed the module) displays information about the module including: general
information about the module (name, serial number, part number), the state of the module (power
down, operational, mismatch between the slot configuration and the module in the slot), and the
number of ports on the module.
For more information about slot status information, see the ExtremeXOS Concepts Guide and the
ExtremeXOS Command Reference Guide.
BlackDiamond 8800 Series Switches Hardware Installation Guide
show slot <slot number>
MSM
command to display slot-specific
I/O Module
LED State/Meaning
STATUS Green blinking
DIAG Off
Port status (per port) Green
Amber blinking
(where <slot> is the number
show slot <slot>
119