BlackDiamond 10808 I/O Modules
Installing a Blank Front Panel
You can install a blank front panel at any time, without causing disruption of network services.
Complete the action of installing a blank front panel in a reasonable time frame to avoid disruption to
adequate airflow.
CAUTION
Never leave a slot without either a module or blank front panel installed. Doing so can cause the
chassis to overheat due to insufficient airflow.
You need the following tools and equipment to install a blank front panel:
• #2 Phillips screwdriver
• Blank front panel
To install the blank front panel:
1 Select a slot for the blank front panel. Slots are numbered 1 through 8 and A or B in the
BlackDiamond 10808 chassis.
2 Attach an ESD strap to your wrist and connect the metal end to the ground receptacle that is located
on the top-left corner of the switch front panel.
3 Slide the blank front panel into the appropriate slot in the chassis.
Ensure that the blank front panel is vertical with the blank front panel number at the top.
76
Extreme Networks BlackDiamond 10K-Series Switch Installation Guide