About; Preferences-About Touchscreen - Euphonix MC Media Application Controller Operation Manual

Euphonix Media Application Controller Operation Manual
To set the brightness of the Soft Keys, use the arrow keys to increase/decrease the illu-
mination (1-10):
• Blue Brightness: Sets the illumination for the blue Soft Keys.
• Green/Orange/Red Brightness: Sets the illumination for the Green/Orange/
Red Soft Keys.
• Contrast: Changes the contrast on all soft keys.
• Dim Level: Sets the illumination for dimmed Soft Keys.
To set the button timing of the Soft Keys, use the arrow keys to increase/decrease the time:
• Latch Timeout: Sets the amount of time (50–500 ms) before a held-down but-
ton becomes momentary or non-latching. For example, a Solo button held
down longer than the Latch Timeout setting becomes non-latching and turns
off when released. Buttons held down for a shorter time than this setting behave
normally (i.e., turn on or off depending on their prior state).
• Repeat Delay: Sets the amount of time (250–1000 ms) before a repeatable but-
ton starts repeating its command when held down (i.e., Nudge or Zoom).
Repeat Rate: Sets the amount of time (30–400 ms) between the repeated commands
when a repeatable button is held down. The button begins repeating after being held
down for the Repeat Delay setting.
4.4

About

This Touchscreen displays the version of the EuCon software loaded on the MC. The
EuConMC software can be upgraded by downloading the latest version from the Eu-
phonix website (see page 18 for instructions).
Figure 4-4 Preferences-About Touchscreen
40
MC Preference Settings