Euphonix MC Media Application Controller Operation Manual page 22

Euphonix Media Application Controller Operation Manual
System 5-MC
The CM408T modules do not allow static IP addressing. Use a DHCP server to auto-
assign their IP addresses. The SonicWALL PRO 1260 router included in the System 5-
MC system is set to perform this function by default.
To set up the System 5-MC network, connect the MC and CM408T modules to the
SonicWALL 1260. The SonicWALL 1260 auto-assigns their IP addresses. The MC
can now recognize the CM408T modules. See Modules (System 5-MC Only) on page
26 to configure the MC to control the CM408T modules.
Euphonix ships the SonicWALL 1260 with all default settings unchanged except the
admin username and password, which are both set to Euphonix. The SonicWALL
1260 checks for a DHCP server on the LAN to which it is attached. If a DHCP server
is not found, it enables its own internal DHCP server.
To access the SonicWALL's web configuration interface:
1. Connect a workstation to one of the 1260's LAN ports.
2. Set the workstation to obtain an IP address automatically using DHCP.
3. Open a web browser and type 192.168.168.168 (the router's default IP address)
into the location address field.
4. Log in to the SonicWALL with the username and password Euphonix.
The SonicWALL Setup Wizard then launches to configure the router settings.
Consult the SonicWALL 1260's manual (included with your System 5-MC or available
at SonicWALL's website) for more information on router settings. Consult your net-
work administrator to find appropriate settings for your LAN.
22
Installation and Configuration