Configure Stp Switch Settings - D-Link DES-3326SRM - Switch - Stackable Product Manual

D-Link DES-3326S Layer 3 Switch
P2P Port
A P2P port is also capable of rapid transition. P2P ports may be used to connect to other bridges. Under RSTP, all ports
operating in full-duplex mode are considered to be P2P ports, unless manually overridden through configuration.
802.1w/802.1d Compatibility
RSTP can interoperate with legacy equipment and is capable of automatically adjusting BPDU packets to 802.1d format when
necessary. However, any segment using 802.1 STP will not benefit from the rapid transition and rapid topology change
detection of RSTP. The protocol also provides for a variable used for migration in the event that legacy equipment on a
segment is updated to use RSTP.

Configure STP Switch Settings

Spanning Tree Protocol operates on two levels: on the switch level, the settings are globally implemented. On the port level,
the settings are implemented on a per user-defined Group of ports basis.
Figure 9- 1. STP switch Settings
62