D-Link DES-3326SRM - Switch - Stackable Product Manual page 53

Configuring a Switch Group for Stacking on page 26 for a description of how to configure the stacking mode. The default
settings allow the slave switches to automatically detect the presence of a Master Switch and determine the stacking order.
Therefore it is only necessary to configure one Switch to be the Master if the remaining slaves are set to their default settings
(config stacking mode enable auto). The CLI command to designate a Master is config stacking mode
enable master.
The switch stack (up to 13 − total) is displayed in the upper right-hand corner of you web-browser. The icons are in the same
order as their respective Unit numbers.
To view the stacking information, use the CLI command show stacking. The illustration below shows a typical Switch stack
information display.
DES-3326S:4#
DES-3326S:4#sh stack
Command: show stacking
ID MAC Address
--- ----------------- ---------- ---------- -------- ----------- ----------
*1 00-00-81-00-01-E0 1 - 26 AUTO
2 00-36-57-01-00-00 27 - 52 AUTO
3 00-00-81-05-02-80 53 - 78 AUTO
Total Entries :3
D-Link DES-3326S Layer 3 Switch
Port Range Mode
4.01-B27 Not Support DES-3326S
4.01-B27 Not Support DES-3326S
4.01-B27 Not Support DES-3326S
Figure 4- 1. Stacking Information
43
Version RPS Status Model Name