Extron electronics CrossPoint 450 Plus Series User Manual page 55

Press and hold the RGBHV button for approximately 2 seconds (fi gure 3-36).
2.
RGBHV
Press and hold the RGBHV button until it blinks.
Figure 3-36 — Select RGB Delay mode
3. Press and release the output 17 button (fi gure 3-37).
1
Press and release the
Output 17 button.
17 18 19
The button lights green.
Figure 3-37 — Select an output
4. Press and release the Esc (
delay by a half second.
Press and release the Esc (
whole second. Note the input button indication changes that occur each time
the Esc (
Figure 3-38 show the result of pressing the Esc (
Press the Esc button to increase the RGB interval that is applied to switches to
the selected output by a half second per button push.
ESC ESC
Figure 3-38 — Adjust the RGB delay interval
N You can press and hold the Esc (
down to the high or low limit.
CrossPoint 450 Plus and MAV Plus Switchers • Operation
2 seconds
= Blinking button
The Input 1 through Input 10 buttons display the selected output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the green input buttons display 3.5 seconds of RGB delay.
0.5 1.0
2 3 1 2
17 18 19 20 21 22 23 24
O
U
T
= Unlit button
>
) button once (fi gure 3-38) to increase the RGB
>
) button twice more to increase the RGB delay by a
>
) button is pressed and released.
0.5 1.0
1 1 2
ESC
17 18 19 20 21 22 23 24
The Input 1 through Input 10 buttons display the selected output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the green input buttons display 5.0 seconds of RGB interval.
= Unlit button
RGBHV
1.5 2.0 2.5 3.0 3.5
3 4 5 6 7 8
= Lit button
>
) button a total of 3 times.
1.5 2.0 2.5 3.0 3.5 4.0
3 4 5 6 7 8
= Lit button
> <
) or View ( ) button to ramp the delay up or
9 10 11
25 26 27
I
N
4.5 5.0
9 10 11
25 26 27
I
N
3-25