Cabling And Rj-45 Connector Wiring - Extron electronics CrossPoint 450 Plus Series User Manual

Cabling and RJ-45 connector wiring

It is vital that your Ethernet cables be the correct cables, and that they be properly
terminated with the correct pinout. Fast Ethernet links use Category (CAT) 5e
or CAT 6, unshielded twisted pair (UTP) or shielded twisted pair (STP) cables,
terminated with RJ-45 connectors. Ethernet cables are limited to a length 328' (100 m).
N Do not use standard telephone cables. Telephone cables will not support
Ethernet or Fast Ethernet.
Do not stretch or bend cables. Transmission errors can occur.
The cable used depends on your network speed. The switcher supports both
10 Mbps (10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet),
half-duplex and full-duplex, Ethernet connections.
• 10Base-T Ethernet requires CAT 3 UTP or STP cable at minimum.
• 100Base-T Fast Ethernet requires CAT 5e UTP or STP cable at minimum.
The Ethernet cable can be terminated as a straight-through cable or a crossover
cable and must be properly terminated for your application (fi gure 2-11).
• Crossover cable — Direct connection between the computer and the
matrix switcher BME 0.
• Patch (straight) cable — Connection of the matrix switcher BME 0 to an
Ethernet LAN.
Side Clip Down
Pins 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1&2
3&6 4&5
Figure 2-11 — RJ-45 connector and pinout tables
CrossPoint 450 Plus and MAV Plus Switchers • Installation
Side 1
Pin Wire color
1 White-orange
2 Orange
RJ-45
3 White-green
connector
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Side 1
Pin Wire color
1 White-orange
Twisted
2 Orange
Pairs
3 White-green
7&8 4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Patch (straight) cable
Side 2
Pin Wire color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Crossover cable
Side 2
Pin Wire color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown
2-9