Jenn-Air JDR8895ACB Use & Care Manual page 7

SURFACE Co KING
To prevent the cooktop from discoloringor
staining:
" CHean cooktop after each use.
Wipe acidic or sugary spills as soon as the cooktop has
cooHedas these spills may discoHorthe
_; UnHikea range with standard gas burners,
this cooktop does not Hilt-up nor is it
removaMe. Do t_ot attempt to lift the
cooktop for any reason.
Burner Grates
The grates must be propedy positioned before cooking.
Lower the grates onto the range so that the bars match up
and the rubber feet Hocatedat the four corners of the grates
sit in the indentations on the cooktop.
Improper installation or removal of the grates may result in
chipping or scratching of the cooktop. It may also cause pans
to be unsteady on the grates.
Seamed Burners
The sealed burner bases of your range are secured to the
cooktop and are not designed to be removed. Since the
burners are sealed into the cooktop, boilovers or spills will not
seep underneath the cooktop.
However, the burner base should be cleaned after each use.
The head portion of the burner has a cap that is easily
removed for cleaning. (See page 21 for cleaning directions._)
Burner caps must be correctly placed on the burner base for
proper operation of the burner.
High Performance Burner
There is one 16,000 BTU_ high speed burner on your range,
located in the left front position. There is a 12,000 BTU*
burner located in the right front position. These burners offer
higher speed cooking that can be used to quickly bring water
to a boil and for large-quantity cooking.
Simmer Burner
Simmer burners are located in tile center and right rear
positions. The simmer burners offer a lower BTU flame for
delicate sauces or melting chocolate.
BTU ratings will vary when using LP gas.
Do not operate the burners without a pan on the grate.
The grate's porcelain finish may chip without a pan to
absorb the heat from the burner flame.
Use care when stirring food in a pot/pan sitting on the burner
grate. The grates have a smooth finish for ease of cleaning.
The pot/pan will slide if the handle is not held. This may result
in spilling of hot food items and may be a burn hazard.
Although the burner grates are durable, they will gradually
lose their shine and/or discolor, due to the high temperatures
of the gas flame.
" A properly adjusted burner with clean ports will light
within a few seconds. If using natural gas, the flame
will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas
mixture may be incorrect. Contact a service technician
to adjust. (Adjustments are not covered by the war-
ranty.)
With LP gas, slight yellow tips on the flames are
acceptable. This is normal and adjustment is not
necessary,.
" With some types of gas, you may hear a "popping"
sound when the surface burner is turned off. This is a
normal operating sound of the burner.
" If the control knob is turned very quickly from High to
Low, the flame may go out, particularly if the burner is
cold. If this occurs, turn the knob to the OFF position,
wait several seconds and rdight the burner.
" The flame should be adjusted so it does not extend
beyond the edge of the pan.