Oven Windows; Upper And Lower Oven Lights - Jenn-Air JDR8895ACB Use & Care Manual

AINTENAN
Oven Doors
• Do not place excesswe weight on or stand on an open
oven door. This could cause the range to tip over, break
the door. or injure the user
, Do not attempt to open or close door or operate oven
until door is properly replaced.
o Never place fingers between hinge and front oven frame.
Hinge arms are sprung mounted. If accidentally hit. the
hinge wiii siam shut against oven frame and could injure
your fingers.
Both the upper and lower oven doors are removable.
To remove:
1. When cool, open the oven door to the broil stop position
(opened about four inches}.
2. Grasp door at each side. Do not use the door handle to lift
door.
3. Lift up evenly until door clears hinge arms.
Oven Windows
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Upper and Lower Oven Lights
-Disconnect power tO oven before tepUacinglight bulb,
' Allow oven to cool before replacing light bulb.
- Make sure bulb cover and bulb are cool before touching.
To replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges.
Door should not appear crooked.
Note: The oven door on a new range may feel "spongy"
when it is closed. This is normal and will decrease with use.
To assure the proper replacement bulb is used, order bulb from
Jenn-Air. Carl 1-800-JENNAIR (1-800-536-6247}, ask for part
number 74009925 - halogen bulb.
To replace oven light bulbs:
1. Disconnect power to tile range.
2. When oven is cool, use fingertips to grasp edge of bulb cover.
Pull out and remove.
3. Carefully remove old bulb by pulling straight out of ceramic
base.
4. To avoid damaging or decreasing the life of the new bulb, do
not touch the bulb with bare hands or fingers. Hold with a
cloth or paper towel. Push new bulb prongs straight into
small hobs of ceramic base.
5. Replace bulb cover by snapping into place.
6. Reconnect power to range. Reset clock.
23