Jenn-Air JDR8895ACB Use & Care Manual page 21

IN
4, Press the Autoset pad.
° "LITE" (Light soft HeveH) is dispHayed.
5. Press the Autoset pad to scroll through the
sdf-deaning settings.
"HVy" (Heavy Soil 4 hours)
"MEd" (Medium Soft,3 hours)
"LITE" (Light Soft, 2 hours)
Choosing the soft Hevdof the oven automatically programs
the sdf-cHeaning time.
6. After four seconds, CLEAN, DELAY and UPPERor LOWER
wflHHightand LOCK wflHflash in the dispHay. When the
oven door Hatches,LOCK wflHstop flashing and Hight
condnuousHy to show that the oven is set for a ddayed
dean operation. The dday time will display.
Autoset
After Self-Cleaning
About one hour after the end of the self-clean cycle, LOCK
will turn off. The doors can then be opened.
Some soil may leave a light gray, powdery ash. Remove
it with a damp cloth. If soil remains after wiping, that means
the clean cycle was not long enough. The soil will be re-
moved during the next clean cycle.
mfoven racks were left in the oven and do not slide
smoothly after a clean cycle, wipe racks and rack supports
with a small amount of vegetable oil to make them easier to
move.
Fine lines may appear in the porcelain because it went
through heating and cooling, This is normal and will not
affect performance,
A white discoloration may appear after cleaning if acidic
or sugary foods were not wiped up before the self-clean
cycle, This discoloration is normal and will not affect perfor-
mance,
During the Self-Clean Cycle
When LOCK shows in the display, both oven doors lock. To
prevent damage to the doors, do not force the doors open
when LOCK is displayed.
Smoke and Smells
You may see some smoke and smell an odor the first few
times the oven is cleaned. This is normal and will lessen in
time.
Smoke may also occur if the oven is heavily soiled or if a
broiler pan was left in the oven.
Sounds
As the oven heats, you may hear sounds of metal parts
expanding and contracting. This is normal and will not
damage the oven.
Self-Clean Notes:
, If an oven door is left open, "door" will appear in the
display and a signal will beep until the door is closed
and the Clean pad is pressed again.
, If more than 30 seconds elapse between pressing the
Clean pad and the Autoset pad, the program will
automatically return to the previous display.
, The oven doors will be damaged if the oven doors are
forced to open when LOCK is still displayed.
2O