Self-Clean Oven - Jenn-Air JDR8895ACB Use & Care Manual

[NG
Self-Clean Oven
is add-resbtant, not acid-proof. The porcelain finish may
discolor if acidic or sugar}, spills are not wiped up before a
self-clean cycle.
• [t is normal for parts of the oven to become hot during a
self-dean cycle
, To pro\ ent damage to oven doors, do not attempt to open
the doors when LOCK is displayed.
• Avoid touching door, window or oven vent area during a
clean cycle
Notes:
° Oven temperature must be below 400° F to program a
clean cycle.
, Only one oven can be cleaned at a time.
Both oven doors lock when either oven is being
cleaned.
- Do not use commercial o\en cleaners on the oven finish
or around any part of the oven. They wiii damage the
finish or parts.
° DO NOT leave baking/p_zza stone in oven during self
dean.
The self-clean cycle uses above-normal cooking temperatures
to automatically dean the oven interior.
It is normal for flare-ups, smoking, or flaming to occur during
cleaning if the oven is heavily soiled. It is better to clean the
oven regularly rather than to wait until there is a heavy build-
up of soil in the oven.
During the cleaning process, the kitchen should be well
ventilated to get rid of normal odors associated with cleaning.
To set Self-Clean:
1. Close the oven door.
2.
3.
Clean ,,
Press the appropriate Clean pad.
° CLEAN flashes. Autoset
° SETand UPPERor LOWER flash in the displai, i
Press the Autoset pad.
° "MEd" (Medium Soil, 3 hours} is displayed.
Press the Autoset pad to scroll through the self-cleaning
settings.
"HVy" (Heaw Soil, 4 hours}
"MEd" (Medium soil, 3 hours}
Before Se[fmCJeaning
1. Turn off the oven light before cleaning as the light may
burn out during the clean cycle.
2. Remove broiler pan, all pans, and oven racks from the
oven. The oven racks will discolor and may not slide easily
after a self-clean cycle if they are not removed.
3. Clean oven frame, door frame (area
outside of gasket, and around the "
opening in the door gasket[) with a
nonabrasive cleaner such as Bon
Ami* or detergent and water. The
self-cleaning process does not
clean these areas. They should be
cleaned to prevent soil from baking on during the clean
cycle. (The gasket is the seal around the oven door and
window.}
4. To prevent damage, do not clean or rub the gasket around
the oven door. The gasket is designed to seal in heat
during the clean cycle.
5. Wipe up excess grease or spillovers from the oven bottom.
This prevents excessive smoking, flare-ups or flaming
during the clean cycle.
6. Wipe up sugar}, and acidic spillovers such as sweet
potatoes, tomato, or milk-based sauces. Porcelain enamel
"LifE" ( Light Soil, 2 hours}
Choosing the soil level of the oven automatically programs
the self-cleaning time.
5. After four seconds, the oven will start cleaning.
° [f the door is not closed, beeps will sound and 'door' will
display. [f the door is not closed within 30 seconds, the
self-cleaning operation will be canceled and the display
will return to the time of day.
° CLEAN will appear in the display.
° LOCK will flash in the display. Once the door locks,
LOCK will remain steady.
° The cleaning time will start counting down in the
display.
To Delay a Self-Clean Cycle: ...... ,
1. Press the Delay pad once for upper oven or
Delay
twice for lower oven. ...........
, DELAY flashes.
, 00:00 and UPPERor LOWER will flash in the display.
2. Enter the amount of time you want to delay the cycle
using the appropriate number pads. .............. \
3. Press the appropriate Clean pad. Clean /
° SETflashes in the display.
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
19