Adding Expansion Cards; Installing Expansion Cards - Intergraph TD-260 System Manual

Adding Expansion Cards

You can add Accelerated Graphics Port (AGP), Peripheral Component Interconnect (PCI),
Plug and Play (PnP), and Industry Standard Architecture (ISA) expansion cards by installing
them in the system's expansion slots. The following figure shows the location of the expansion
slots on the system board. Install PnP cards in any expansion slot. The lowest PCI slot and the
highest ISA slot are shared; you can install an expansion card into one or the other, but not
both.
NOTE Plug and Play (PnP) support is not currently available in Windows NT.
NOTE Expansion slots are half-length in a TD-260 mini-tower, and full-length in a TD-260 desktop.

Installing Expansion Cards

Follow the steps below to install a new expansion card in an open expansion slot.
To install a new expansion card:
1. Remove the base unit cover as described previously in "Opening the Base Unit."
2. Remove the screw securing the blanking plate of an empty expansion slot, and remove the
blanking plate.
3. Insert the expansion card into the expansion slot, using firm and steady pressure.
CAUTION Do not rock or tilt the expansion card. Doing so might damage the card, the slot, or both.
AGP
PCI
ISA
45