Fax Setup - Xerox WorkCentre 3550 User Manual

Fax Setup

Fax Setup

Your machine provides you with various user-selectable options for setting up the fax system. You can
change the default settings for your preferences and needs.
Enable/Disable
Use this option to enable or disable the Fax service:
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight Fax Setup and press OK.
3. Enter the Administrator's Password using the keypad. Refer to
page 128 for instructions.
4. Press the up/down arrows to highlight Enable/Disable and press OK.
5. Press the up/down arrows to highlight Enabled or Disabled. Press OK.
6. Press Stop to return to ready mode.
Sending
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight Fax Setup and press OK.
3. Enter the Administrator's Password using the keypad. Refer to
page 128 for instructions.
4. Press the up/down arrows to highlight Sending and press OK.
The following Sending options and settings are available:
Note: * indicates the factory default setting.
Option
Redial Times
Redial Term
Prefix Dial
140 Xerox WorkCentre 3550
User Guide
Description
You can specify the number of
redial attempts. If you enter 0,
the machine will not redial.
Your machine can automatically
redial a remote fax machine if it
was busy. You can set an interval
between attempts.
You can set a prefix of up to five
digits. This number dials before
any automatic dial number is
started.
Accessing the Setup Options
Accessing the Setup Options
Settings
• 0 - 13 Times
• 1 - 15 Minutes
• Fax:
on
on