Xerox WorkCentre 3550 User Manual page 148

System Setup
Option
Power Save
Scan PWR Save
Menu Timeout
Held Job Timeout
Banner Sheet
Configuration Page
Altitude Adj.
148 Xerox WorkCentre 3550
User Guide
Description
Use this option to set the time
the machine waits before
entering power save mode.
Scan power save mode allows
you to save power by turning off
the scan lamp. The scan lamp
automatically turns off when it
is not in use to reduce power
consumption and extend the life
of the lamp. The lamp
automatically wakes up after
some warm-up time when you
start scanning.
Use to set the time the machine
waits before it restores the
default settings.
Use to enable the machine to
delete jobs which have been
held in the job list for a specified
period of time and have not
been cleared by a user.
The machine can print a banner
sheet with every print job.
If enabled the machine prints
the configuration report when
the device is powered on.
The xerographic process used in
your machine to make prints is
affected by air pressure. Air
pressure is determined by the
height of the machine above
sea level. The machine will
automatically compensate for
differences in air pressure if you
enable the feature.
Settings
• 5 Min
• 10 Min
• 15 Min
• 20 Min
• 30 Min *
• 45 Min
• 60 Min
• 120 Min
• 30 Min *
• 60 Min
• 120 Min
• Off
• 15 Sec
• 30 Sec *
• 60 Sec
• 120 Sec
• 180 Sec
• Enable *
• Disable
• Enable *
• Disable
• Enable
• Disable
• Normal *
• High 1