Loading Paper - Xerox WorkCentre 3550 User Manual

Loading Paper

1. Open the paper tray.
The paper level indicator on the front of the tray 1 and the
optional tray 2 shows the amount of paper currently left in
the tray. When the tray is empty, the indicator of the bar is
completely lowered.
Note: The paper trays can each hold a maximum of 500
sheets of 20 lb (80 g/m²) bond paper. The bypass tray can
hold 50 sheets 20 lb (80 g/m²) bond paper.
2. If loading Legal, Oficio and Folio open the back of the paper
tray.
3. Squeeze the rear guide and move from the current position
and into the correct position for the current paper size. Make
sure the guide clicks into place.
4. Load paper into the tray. Do not fill above the 28lb (105g)
line at the rear of the tray.
5. Position the side guide by squeezing the lever and sliding it
towards the stack of paper, until it gently touches the side of
the stack.
6. Insert the paper tray into the machine.
7. After loading paper in the paper tray, set the paper size and
type using the control panel. Press OK to confirm the settings
or Stop to change the settings. These settings will apply to
Copy and Fax modes.
For workstation printing, select the paper size and type in the application program you use on your
workstation.
Note: The settings made from the print driver override the settings on the control panel.
For more information on loading paper, refer to Paper and Media on page 117.

Loading Paper

Xerox WorkCentre 3550
User Guide
17